17

2022

-

06

Stainless steel pressure tank leakage how to repair?

作者:


Stainless steel pressure tankHow to repair leaks?

Stainless steel tanks have been around for a long time。Due to the cracks, sand holes, wear, welds and other defects of the tank itself, water leakage and oil leakage will occur under the action of pressure。If it is re-welded, it is not easy to operate, and there are security risks during construction。Stainless steel pressure tank leakage how to repair?

Stainless steel pressure tankHow to repair leaks?

1.First of all, you need to find the leak point, clean the stainless steel barrel inside and outside to avoid dust。Sand the leak until it's perfectly flat。Prepare special stainless steel glue, wipe the smeared part clean and keep it dry, and then evenly smear it on the leaking part with a piece of stainless steel on the surface。Welding method can be selected to avoid future water leakage。

2.If there is no special stainless steel adhesive, you can also use a steel repair agent instead。Mix well according to the instructions, and then apply the repair evenly to the cracks and cracks。When it is fully cured, it can be repaired by machining。

3.The water leakage should be polished by mechanical grinding, if the crack should be removed, if the porosity inclusion should be removed, and then the appropriate welding material should be used for the second welding repair。Welding repair is divided into two types, respectively, with water and without water repair。With water repair, in terms of safety and success rate, it is better to take the underwater welding rod of BROCO in the United States, without water, it is recommended to use WEWELDING600 welding rod with excellent crack resistance to repair。

Stainless steel pressure tankWhat is the use and maintenance method?

1.The installation of the device needs to choose a place with good ventilation, less dust and no humidity, and the ambient humidity is between minus 10 degrees Celsius and 40 degrees Celsius。Outdoor facilities such as rain and lightning protection are required。

2.In order to facilitate the installation and maintenance of the device, a space of 70 cm should be left around the device, and a space of 1 should be left at the manhole.5 meters of space, the ground should be set around the gutter。

3.After site selection, the foundation should be treated, and the tank support should be poured with concrete or masonry。After the base is cured, the tank is lifted and stabilized, and then accessories are installed and power is connected。

4.Before the test run, it is necessary to close the water supply valve, check the condition of each sealing valve, and do not allow leakage。After driving, pay attention to the steering of the pump。When the pressure gauge pointer reaches the upper limit, the pump will automatically end。Open the water supply valve and supply water normally。If timed water supply is required, switch the selection switch to the manual position。

5.The automatic control system of electrical appliances needs to be waterproof and dust-proof。Always check the insulation of the line, whether the connection bolts are loose, and whether the fuse is intact。The surface of the pressure gauge should be covered with transparent material as far as possible to avoid damage。

6.If the pressure tank is painted or falls off, it should be painted and maintained immediately to help extend the service life。


Stainless steel pressure tank